A standard 18” wide wheelchair fits easily under the Worksurface (as shown). The Worksurface has a rounded cutout across the front edge, similar to a wheelchair lap tray, for increased contact, improved upper extremity positioning, and support for the user. A great addition to a kitchen if used with a cutting board. It features an extra large, 29 1/2” wide x 28” deep worksurface and a longer base for stability.

It comes complete with a Leg Height Set that allows it to be made into a desk or table that can be set at the precise height and angle required by the user depending on specific needs at the time. Once the height is set the angle is easily adjusted with the slot design on the sides. Note: The height range will vary slightly when the Worksurface is angled.

Adaptive Worksurface Specifications
Width: 24”
Depth: 20”
Cutout Width: 12”
Inside Width of Worksurface Top: 24 1/2”
Inside Width of Leg Height Set: 26”

Select one of the following based on the user's seated body measurement from their bent elbow to the floor:
Low Leg Height Set
The height between the front edge (positioned at it's standard horizontal setting) and the floor will be 20”- 30”

Medium Leg Height Set
The height between the front edge (positioned at it's standard horizontal setting) and the floor will be 27”- 37”

Tall Leg Height Set
The height between the front edge (positioned at it's standard horizontal setting) and the floor will be 34”- 44”

Availability: Usually ships in 2-3 weeks.

100TE
Leg Height Set: LowMediumTall